
Why rainwater is worth the effort
By mid-July, many a garden is running on optimism and a hosepipe. Rainwater is free, it arrives soft rather than hardened by the water treatment works, and plants have been drinking it for millions of years. Tap water carries chlorine and, in much of the UK, a generous dose of dissolved calcium. Rainwater sits at around pH 6 and leaves no chalky film on pots, leaves or greenhouse glass.
That difference matters most to ericaceous plants. Blueberries, camellias, rhododendrons, heathers Piers and Japanese maples will thank you for it, as will seedlings, ferns and anything growing in a container where lime gradually builds up in the compost. Topping up a pond with rainwater avoids feeding the algae that tap water's nutrients encourage.
There is a practical argument too. A hosepipe ban usually exempts stored rainwater, so a butt keeps your pots alive through the driest fortnight of the year. And the maths is generous: 1mm of rain falling on 1m² of roof yields one litre. Even a modest shed roof can fill a butt faster than you expect.
Choosing, sizing and siting your water butt
Most garden butts hold between 100 and 250 litres. A 100-litre butt fills after 10mm of rain on a 10m² roof, which is a fairly ordinary summer shower over a garage. If you have the space, link two butts with a connector kit and double your capacity for very little extra effort.
- Base: a full 200-litre butt weighs over 200kg. Stand it on firm, level paving or a proper plinth, never bare soil that will settle and tip it.
- Height: raise the butt on a purpose-made stand, roughly 30–45cm, so a watering can fits comfortably under the tap. Gravity is your only pump.
- Position: close to the pots, beds or greenhouse you water most. A butt at the far end of the plot will be used far less often than one by the back door.
- Shade: keep it out of direct sun where you can. Cool water loses less to evaporation and grows less algae.
- Overflow: always fit one, and direct it onto a bed or soakaway well away from the house foundations.
Fitting a diverter: the practical bit
A downpipe diverter is a small, inexpensive unit that sits in your existing downpipe and sends water sideways into the butt. Mark a point on the downpipe just above the top of the butt, then cut out a section of about 5–10cm with a hacksaw. Slot the diverter in, connect its flexible hose to the butt's inlet, and check that the pipe still drains freely.
The clever part is that when the butt is full, the diverter simply lets water carry on down the drain, so you never flood the garden or back up the gutter. Fit it on plastic downpipe where possible; cast iron or unusually shaped pipes may need a different approach, such as a rainwater hopper or a simple diverter that clips around the pipe. If your butt sits a long way from the wall, keep the connecting hose short and sloping gently downhill, or the water will refuse to cooperate.
Keeping stored water clean, safe and midge-free
Rainwater is not sterile, and a warm, open butt is a tempting nursery for midges and mosquitoes. Keep a lid on at all times and fit fine mesh over the inlet to catch leaves, moss and grit. Dark or opaque butts limit algae; if yours is translucent, shade it. A filter on the tap is worth having if you plan to run drip lines, since grit blocks narrow pipes very quickly.
Safety deserves a mention. Even a shallow butt is a drowning risk for small children and pets, so secure the lid firmly and consider draining or fencing the butt if little ones are about. Clean your gutters each autumn, before the heavy rain arrives, and empty and rinse the butt every year or two.
One caution: avoid using water collected from roofs with lead flashing or old bitumen felt on vegetables and herbs. It is perfectly fine for flowers, shrubs and lawns.
Watering well: making every litre count
How you water matters as much as what you water with. Aim for early morning or early evening, when evaporation is lowest, and soak thoroughly rather than giving a daily sprinkle. A pot should be watered until it runs out of the drainage holes; a light surface splash only encourages shallow roots.
- Mulch beds with 5cm of composted bark or straw to slow evaporation from the soil surface.
- Group pots together and stand them on saucers or capillary matting to reduce losses.
- Run gravity-fed drip lines from the butt along greenhouse beds and tomato pots.
- Keep a watering can permanently at the butt, so filling it never feels like a chore.
- Water at the base of the plant, not over the leaves, to reduce disease and waste.
A year-round routine
In autumn, clear the gutters, rinse the filter and check the diverter and overflow are clear before winter rain. In spring, inspect the tap, seals and stand, and make sure the butt isn't sitting in a frost pocket where ice can strain the base. Through summer, use the water steadily rather than letting it stand for months, and top up your watering routine before a hot spell rather than after the leaves have already drooped.
Set up one butt this season and you will wonder why you waited so long. It costs little, saves money on metered water, keeps the garden thriving through dry spells, and turns every passing shower into something genuinely useful.
Leave a reply